Email： [email protected]
Phone：0086-13929992673
Address： Wufuwei Industrial Zone,Pingzhou,Nanhai,Foshan,Guangdong,China
-
Dry Powder Blending Machine: Vertical Ribbon Mixer | JCT Machinery
Design of Vertical Ribbon Mixer 1. Transmission System Double vertical ribbon mixer has the rotation motion of the spiral shaft and the revolution motion of the rotating arm along the cylinder wall. The revolution and rotation adopt separate transmi
-
Liquid Silicone Rubber | JCT Machinery
What is liquid silicone rubber? Liquid silicone rubber (LSR) is typically made up of two main components: a liquid silicone polymer and a catalyst that initiates the curing process. Characteristics of Liquid Silicone Rubber 1. Flexibility and
-
Different Kinds Of Silicone Sealant | JCT Machinery
What is silicone sealant? Acidic silicone sealant and neutral silicone sealant are both used in construction. However, acidic silicone sealant is slightly corrosive to steel, cement, stone, etc. due to the presence of acidic components, so its applicat
-
Neoprene Adhesive Manufacturing Equipment and Process | JCT Machinery
What is neoprene adhesive? Neoprene was the first synthetic rubber compound to be mass-produced. As an adhesive, neoprene adhesive had a wide range of applications. It has the characteristics of large initial adhesion and high bonding strength. It is m
-
Dry Powder Blending Machine: Conical Screw Mixer and Horizontal Ribbon Blender | JCT Machinery
What is dry powder blending machine? Conical Screw Mixer : This type of mixer is suitable for mixing and stirring dry powder and granular materials, including powders, granules, crystals, etc. Conical screw mixer features one or more spiral-sha
-
What Should I Do If Sigma Mixer Leaks Oil? | JCT Machinery
1. Check Seals First check the seals of sigma mixer, including shaft seals, sealing rings, etc., to ensure that they are not worn, aged or damaged. If any problem is found, replace the seal in time. 2. Check Bearings Check sigma mixer's beari
-
Sigma Mixer Shaft Wear Repair | JCT Machinery
Why is there wear and tear? Wear on the bearing positions and bearing chambers of sigma mixer is generally caused by component dimensional tolerances, assembly processes, and wear in heacy-load operating environments. Once wear occurs, it will inevitab
-
Common Faults And Solutions Of Sigma Mixer | JCT Machinery
1. Sigma Mixer Motor Cannot Start Normally or Runs Unstable Power Failure : Check whether the power cord is in good contact and whether the power switch is turned on. Motor Failure : Check whether the motor has circuit or winding open ci
-
Paint Production Line Machine | JCT Machinery
What is paint? Paint is a coating that usually consists of pigments, solvents, resins (or polymers) and auxiliary additives. It is widely used to coat and protect surfaces, improve appearance and provide anti-corrosion, weather resistance, waterproofin
-
Electric Heating Reactor | JCT Machinery
Why choose electric heating reactor? The electric heating reactor has the characteristics of rapid heating, high temperature resistance, corrosion resistance, hygiene, no environmental pollution, no need for autoomatic boiler heating, easy use and low
